Call us: 877-860-5666

The Clevis Head Innerduct Pulling Eye comes with the same tapered threads as the standard innerduct pulling eye. These feature a slotted head with clevis pin to permit direct attachment to any Condux multiple pulling harness leg ends. When properly sized and installed, these eyes will not pull out of the innerduct until the pulling tensions have greatly exceeded the maximum pulling tensions recommended by the innerduct manufacturers.

Contact us if you have any questions.


Clevis Head Innerduct Pulling Eye

NOTE:  To determine correct pulling eye size, obtain the actual innerduct inside diameter (I.D.).  The I.D. measurement must be greater than dimension A and smaller than dimension B.

Product Catalog

Additional information

Nominal Duct Size

.75", 1", 1.25", 1.5", 1.75", 2"




Be the first to review “CONDUX Clevis Head Innerduct Pulling Eyes”

Your Opinion Counts!

We really want your feedback on the products we sell at Tallman Equipment. If you’ve used any of the products we sell (whether you bought them from us or not), leave a review on our website. After writing just 3 reviews, you can receive a free Tallman t-shirt. 

Share This